AvaSpark
Pint/PintX Ubox100 lite DIY Kit
Pint/PintX Ubox100 lite DIY Kit
Couldn't load pickup availability
Everything you need to add Vesc to your onewheel Pint or PintX
Comes Pre wired! pre flash with firmware *no need to update*
MANDATORY READING MATERIAL
Installation video
https://www.youtube.com/watch?v=j9t9IeRBfro
This is the recommended software setup video or float hub
https://www.youtube.com/watch?
DIY Kit comes with
- Ubox 100 lite in Metal housing (with power connector to fit Pint harness)
- Bluetooth module
- Foot pad Connector
- Motor Connector
- Stock button adapter (push for 1/2 sec to turn on, push for 2 sec and release to turn off, 30 min auto shut off)
- Metal mount for Ubox 100 lite (good for up to 20S batteries)
- Thermal pad/paste
- BMS Fuse 60A
- LED controller and buck power supply
BMS available here
recommended solder
https://amzn.to/4fT0qC8
recommended silicone
https://amzn.to/4j6W4KH
soldering iron
https://amzn.to/4gNCykT
Share
Great service. Great products.
Took about 2 hours to install the controller. Ended up running a flipsky BMS and wired it directly to the battery so that took me a bit longer. Pretty straightforward install!
Really good gumstick is a life saver
The level of attention to detail in prewiring harnesses , VESC mounts and special 3D printed parts combined with a tutorial video makes this kit the best choice for the price . If you run into any problems, customer care is quick to respond and assist in resparking the stoke to your Pint(X).
-Matthew Ahrens
@drumbeater82
A while back I broke my original control board and chose to dive into the world of VESC. I’m not very knowledgeable and there’s not much consistent information on how to do this. I struggled a lot with basic issues but Marcello helped me over email for months as I fumbled through the process. Even if this is a huge challenge having them in your corner means you won’t fail.
